Dell Vostro 3710 Service Manual page 52

Steps
1. Slide the system board at an angle with the rear external ports aligned to their respective openings of back panel at the rear
of the chassis.
2. Place the system board onto the chassis and ensure the front I/O-ports are placed into the front I/O-slots on the chassis.
3. Replace the seven screws (#6-32) and the screw (#6-32x3.8) that secure the system board to the chassis.
4. Route and connect the following cables to the system board. See the
the respective connectors of the following cables:
● hard-drive and optical-drive power cable
● optical-drive data cable
● hard-drive data cable
● system-board power cable
● power-button cable
● processor-power cable
5. Place and align the front I/O-bracket with I/O slot on the chassis.
6. Replace the screw (#6-32) that secures the front I/O-bracket to the chassis.
Next steps
1. Install the processor.
2. Install the fan and heat-sink
3. Install the fan shroud.
4. Install the media-card
5. Install the coin-cell battery.
6. Install the wireless card.
7. Install the M.2 2230 solid-state drive
8. Install the memory.
9. Install the HDD and ODD
10. Install the 3.5-inch hard
11. Install the front cover.
12. Install the left-side cover.
13. Follow the procedure in
52 Removing and installing components
assembly.
reader.
or M.2 2280 solid-state
cage.
drive.
After working inside your
system-board components
drive, which is applicable.
computer.
for more information about