Setting Up Oki Dicom Embedded Printer; Install The Printer - Oki ES6410 DICOM User Manual

1. Setting up OKI DICOM Embedded
Printer

1-1 Install the printer

The following procedures are performed in accordance with the Setup Guide/User's
Guide/Network Guide supplied on CD/DVD with the printer.
(1) Unpack OKI DICOM Embedded Printer (hereinafter referred to as printer) from
the packing box and install it.
(2) Remove the protective tapes and the protective sheets from the printer.
(3) Open the top cover, and remove the stopper (orange) of the fuser unit.
(4) Install the image drum.
(5) Load paper on the paper tray.
(6) Connect the AC cord to the printer, and turn on the power.
Note: Do not connect the network cable to the printer yet.
(7) Enter the IP address, which is provided by your network administrator, using
the printer control panel.
(8) Perform test printing, and confirm that the IP address is set for the printer
correctly.
(9) Connect the network cable to the printer.
(10) Shutdown the printer and turn off power.
(11) Turn on power. After finishing required process, the printer reboots
automatically.
Next, set up the printer from your PC (Personal Computer) as instructed as follows.
Prepare a PC connected to the same network as the printer.
Copyright © 2016 Oki Data Corporation. All rights reserved.
10