Getting Started - Zte MY39 User Manual

2. Remove the hardware. Right click on the PCMCIA icon circled below in your system
tray and left click close.
3. Select the NEC PCI to USB Open Host Controller.
4. Click Stop in the device pop-up screen.
5. Push the laptop latch release, and then pull the netcard out of the slot.
Note: Once the netcard is inserted, do not physically remove the ZTE MY39 from the Card slot
until you have completed the Unplug process. Removing the card improperly may cause a fatal
error to your laptop.

2.6 Getting started

After the software and hardware is installed and connected normally, the Service LED is
lighted. Click the windows Start menu and select ZTE WIRLESS CARD→ ZTE MY39 from the
list of programs.
Or double click on the shortcut icon
After wireless netcard is initialized, main interface appears. When the standby icon
appears, the card can work properly.
Retransmission and reproduction in any manner whatsoever without the permission of ZTE is strictly forbidden. All rights reserved.
on your desktop.
10
内部公开▲