Front Panel; Set-Up - THOMSON LDK 4502 User Manual

Front panel

1
1
Display
During normal operation the display shows the number of the
camera connected to the Base Station.
When the set-up control (located behind the left front cover)
is activated, the display shows a two letter code to identify the
set-up function (see Set-Up).
The display can be switched on or off via the Base Station
menu system.
2
Intercom volume control
Adjusts the volume of the selected intercom channel being
monitored on the connector below.
3
Intercom selection switch
Use this switch to select the intercom channel that is monitored
on the connector below.
4
Intercom connector
Connect a headset to this connector to monitor the selected
intercom channel.
5
Camera Communication
This green LED lights when the communications between
Camera and Base Station are OK.
Operating Instructions
2 3
HDTV
User's Guide LDK 4502 - HDTV Camera Base Station
4 5 6
Prod
Prog
Cam +Floor
Eng
Camera On Air
Communication
Camera Base Station
6
On Air and ISO indicators
The red LED lights when the Camera is On Air.
If the Camera is selected as ISO Camera the yellow LED
lights.
7
Power Switch
Switches the power supply to the Base Station on and off. A
built-in light lights to indicate that the power is ON.
8
Base Station
This green LED lights when the Base Station is operationally
ready.
9
Camera indicators
This bicolour TEST LED lights red or yellow to indicate the
Camera and Triax status:
- Red lights continuously – Triax short circuit.
- Red flashes – Triax open circuit.
- Yellow – Camera power switched off with the
Operational or Master Control Panel.
This green CONNECTED LED lights when the Camera is
connected and the Camera power switch is On.
7 8 9
Base Camera
Station Test Connected
3-3