Table of Contents
Advertisement
•
To modify the settings, return the teeth to the initial
position and set the new operating periods.
•
To turn the appliance off, turn the power selector to "0".
MAINTENANCE
Before carrying out any maintenance, disconnect the ap-
pliance from the power supply and wait for it to cool down
completely.
This appliance requires no particular maintenance.
It is sufficient to remove dust with a soft, dry cloth. Never use
abrasive powders or solvents. If necessary remove areas of
concentrated dirt with a vacuum cleaner.
TECHNICAL CHARACTERISTICS
Power supply
Power consumption
TROUBLESHOOTING
PROBLEM
The appliance doesn't
work
See appliance rating plate
"
CAUSE
The plug is not inserted properly into the po-
wer socket or the socket switch is off.
Check for any obstruction.
The power selector is in the "0" position.
The thermostat is set too low.
Timer setting.
An anti-tilt safety device is activated.
Insert the plug into the power socket and
switch on if necessary.
Remove the obstruction, disconnect the po-
wer plug of the heater and let the appliance
cool down. If the problem persists, contact
customer experience.
Move the power selector to position MIN, MED,
MAX or MAX
Turn the thermostat knob clockwise to higher
settings until the heater restarts.
Make sure the timer is correctly set to local
time and check the position of the teeth.
Make sure the appliance is standing upright
on a flat surface, if the problem persists con-
tact our toll free number to assist you.
7
SOLUTION
.
Advertisement
Table of Contents
