Yamaha ZUMA 2022 Owner's Manual page 80

Scooter care and storage
perform any outstanding mainte-
1
nance.
2. Follow all instructions in the Care
2 section of this chapter.
3. Fill up the fuel tank, adding fuel
stabilizer according to product in-
3
structions. Run the engine for 5
minutes to distribute treated fuel
4
through the fuel system.
4. For vehicles equipped with a fuel
cock: Turn the fuel cock lever to
5
the off position.
5. For vehicles with a carburetor: To
6
prevent fuel deposits from building
up, drain the fuel in the carburetor
7
float chamber into a clean contain-
er. Retighten the drain bolt and
pour the fuel back into the fuel
8
tank.
6. Use a quality engine fogging oil
9
(YAMALUBE
Fogging Oil) according to product
10
instructions to protect internal en-
gine components from corrosion. If
engine fogging oil is not available,
11
perform the following steps for
each cylinder:
12
a. Remove the spark plug cap
and spark plug.
Stor-Rite Engine
7. Lubricate all control cables, pivots,
8. Check and correct the tire air pres-
b. Pour a teaspoonful of engine oil
into the spark plug bore.
c. Install the spark plug cap onto
the spark plug, and then place
the spark plug on the cylinder
head so that the electrodes are
grounded. (This will limit spark-
ing during the next step.)
d. Turn the engine over several
times with the starter. (This will
coat the cylinder wall with oil.)
WARNING! To prevent dam-
age or injury from sparking,
make sure to ground the
spark plug electrodes while
turning the
over.
[EWA10952]
e. Remove the spark plug cap
from the spark plug, and then
install the spark plug and the
spark plug cap.
levers and pedals, as well as the
sidestand and centerstand (if
equipped).
sure, and then lift the vehicle so
that all wheels are off the ground.
Otherwise, turn the wheels a little
8-4
once a month in order to prevent
the tires from becoming degraded
in one spot.
9. Cover the muffler outlet with a
plastic bag to prevent moisture
from entering it.
10. Remove the battery and fully
charge it, or attach a maintenance
charger to keep the battery opti-
mally charged. NOTICE: Confirm
that the battery and its charger
are compatible. Do not charge a
VRLA battery with a convention-
al charger.
TIP
engine

If the battery will be removed,
charge it once a month and store it
in a temperate location between
32-90 F (0-30 C).

See page 7-27 for more informa-
tion on charging and storing the
battery.
[ECA26330]