Playing Back A Selected Track; Repeating Playback; Programmed Playback - Tascam CD-RW5000 Owner's Manual

3 - Playback operations
This section gives details of the basic operations you
can perform when using the CD-RW5000 to play
back CDs.
Playing back CDs on the CD-RW5000 is similar to
playing back CDs on any other CD player.
The CD-RW5000 can play back ordinary
pre-recorded commercial CDs, and CD-R discs, as
well as CD-RW discs recorded on the CD-RW5000.
These last discs may not be playable on other CD
players.
Also, note that unlike some other CD players, but in
common with other TASCAM devices, the PLAY
key on the CD-RW5000 is used to restart playback
after the PAUSE key has been used to pause play-
back.
3.1 Display modes
The different display modes available when playing
back a CD are: track elapsed time ( TRACK TIME )
with the level meters displayed, track remaining time
( REMAIN TIME TRACK ), disc remaining time
( TOTAL REMAIN TIME ), and track elapsed time
( TRACK TIME ) without the level meters displayed.
Press the DISPLAY key ([6] or [34]) to cycle
between these modes.

3.2 Playing back a selected track

Use the number buttons on the remote control unit to
enter a track number. If the number of the track is
greater than nine, press the keys of the two digits in
order to enter the 2-digit number.
• If the CD-RW5000 is already playing, the playback
will jump to the start of the selected track.
• If the CD-RW5000 is in pause mode, the playback
position will be at the start of the selected track in
pause mode.
• If the CD-RW5000 is stopped, playback will start
from the start of the selected track.

3.3 Repeating playback

1
To repeat one track, press the REPEAT key
[32] on the remote control unit once to show
REPEAT 1 on the display. The current
track will continue to be repeated until
stopped.
14
TASCAM CD-RW5000
2
To repeat the whole disc, press the REPEAT
key [32] on the remote control unit twice to
show REPEAT ALL on the display. The disc
will play to the end and then restart playing
from the beginning until stopped.

3.3.1 Programmed playback

To program a sequence of tracks for playback, follow
the steps below:
1
Make sure that playback is stopped.
2
Press the PGM key [33], and
is shown on the display.
3
Enter the numbers of the tracks that you
want included in the programmed play,
using the number keys on the remote control
unit [31].
The step number of the programmed track appears
briefly, and the display shows the word
PROGRAM flashing at the left of the display.
NOTE
As explained earlier, pressing two number
keys in quick succession will enter that 2-digit
track number. Leave a pause between the
entry of the different track numbers to sepa-
rate the program steps.
4
Start the programmed playback by pressing
the PLAY key on the main unit [15] or on the
remote control unit [43].
5
Stop programmed playback by pressing the
STOP key on the main unit [14] or on the
remote control unit [42].
While a programmed playback sequence is active,
even while playback is stopped, the display shows
the word PROGRAM at the left of the display.
6
Cancel programmed playback by pressing
the STOP key on the main unit [14] or on the
remote control unit [42] twice in quick
succession.
Opening the disc tray will also cancel the pro-
grammed playback.
It is possible to program up to 20 program steps for
programmed playback. If more than 20 program
steps are entered, the display shows FULL .
PROGRAM