Husqvarna 525RJX Operator's Manual page 7

machine is not a servicing dealer, ask him
for the address of your nearest service
agent.
To do a check of the throttle trigger lockout
The throttle lockout is designed to prevent accidental
operation of the throttle control.
1. Press the throttle trigger lockout (A) and make
sure that the throttle control is released (B). When
you release the handle the throttle control and
the throttle trigger lockout both move back to their
initial positions. This movement is controlled by
two independent return springs. This arrangement
means that the throttle control is automatically
locked at the idle setting.
B
2. Make sure that the throttle control is locked at
the idle setting when the throttle trigger lockout is
released.
3. Press the throttle trigger lockout and make sure that
it returns to its intial position when you release it.
4. Do a check of the throttle control and throttle trigger
lockout move freely and that the return springs work
properly.
1927 - 001 - 10.06.2022
A
5. Start the product (refer to the instructions under
start the product on page 15 ) and apply full throttle.
6. Release the throttle and make sure that the cutting
attachment stops and remains at a standstill. If the
cutting attachment rotates with the throttle in the idle
position the carburettor idle setting must be checked.
See instructions under the chapter
speed on page 19 .
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the cutting attachment guard
WARNING:
attachment without an approved and
correctly attached cutting attachment guard.
To assemble the cutting attachment
See
guard and trimmer head on page 11 .
WARNING:
recommended cutting attachment guard for
the cutting attachment that you use. If
an incorrect or faulty cutting attachment
guard is fitted this can cause serious
personal injury. See intructions under
Accessories on page 23 .
heading
The cutting attachment guard prevents injuries from
objects that eject in the direction of the operator. It
To
To adjust the idle
Do not use a cutting
Always use the
7