Table of Contents
Advertisement
Cleaning and maintenance
Remove any objects from the
pump impeller by rotating it.
Put the cap back on the emer-
gency emptying hose and place
the latter back in its seat.
Screw the pump fully in.
Close the pump door.
Water inlet filter
If you notice that the machine is
taking longer to fill, check that the
filter in the water inlet hose is not
blocked.
Turn off the water tap.
Unscrew the hose from the tap.
Clean the filter in the hose with a stiff brush.
Screw the hose back onto the tap.
Emergency emptying out
If the water is not discharged, proceed as fol-
lows to empty out the machine:
pull out the plug from the power socket;
close the water tap;
if necessary, wait until the water has cooled down;
open the the pump door;
place a bowl on the floor and place the end of the emergency emptying hose
into the bowl. Remove its cap. The water should drain by gravity into the
bowl. Whe the bowl is full, put the cap back on the hose. Empty the bowl.
Repeat the procedure until water stops flowing out;
clean the pump if necessary as previously described;
replace the emergency emptying hose in its seat after having plugged it;
screw the pump again and close the door.
73
Advertisement
Table of Contents
