Central Station Talk/Listen-In Commands - DSC MAXSYS PC4936 Instruction Manual

4.10 Central Station Talk/Listen-In Commands

Ref #: [001604XX], where XX = key number 00-11
Ref #: [001605XX], where XX = mode key number 00-11
When the panel transmits a reporting code to central station and Talk/Lis-
ten-In is initiated, the panel will pass the telephone line to the PC4936 for
Talk/Listen-In. The PC4936 will then turn on the closest station to the alarm,
or, if the CS Listen All option is enabled, all stations will turn on.
Once the central station has established the Talk/Listen-in link the operators
can control the session by pressing keys [0] through [9], [#] and [*] on their
Touch-Tone telephone. Additional commands can be programmed as Mode
Keys, which are two button entries on the Touch-Tone telephone.
The central station may be using other Talk/Listen-In equipment. You can
program the PC4936 so that central station operators can use the same com-
mands for all equipment. Ask your central station how they need the com-
mand keys to be programmed.
The following commands are available:
00
Key not used
01
Talk to all speakers
02
For future use
03
High gain listen to all
04
For future use
05
For future use
06
Low gain listen to all
07
Extend time
08
For future use
14
firealarmresources.com
09
Terminate session
10
For future use
11
Cancel keypress
12
For future use
13
Zone select
14
Increase microphone input
15
Decrease microphone input
16
For future use
17
Mode key