Table of Contents
Advertisement
ond. Once the call is answered the audio channel will operate the same as it
does for a page.
The call will end if the user presses and holds the Page/Answer button for 1
second. The call will also end after 30 seconds of silence.
If a page is in progress when an incoming call is detected only the two users
on the page will hear the ring. To answer the call either user can press and
hold the Page/Answer button for 1 second. The page will end and the user
will immediately be connected to the incoming call.
If a user has answered a telephone call at an intercom station and then the
doorbell is pressed, the user will hear the doorbell. The user can press Page/
Answer to hang up the telephone, and then press Page/Answer one more
time to answer the doorbell.
3.10 Transferring and Holding Calls
Once a user has answered a call on an intercom station, they can:
• put the call on hold
• transfer the call to an in-house telephone
• page someone so that the they can answer the call at another intercom station
To put a call on hold press the Do Not Disturb button once. Once the call is
on hold, you can page someone else to answer the call, or answer door-
bells as usual.
To pick up a holding call at a telephone, go to the telephone, pick up the
receiver and press the [#] key for 1 second. This puts the call through to the
telephone and disconnects the intercom station from the conversation.
To pick up a holding call at any intercom station, press the Do Not Disturb
button.
3.11 Call Waiting
If you have answered the telephone through an audio station and a second
call comes in, the station will ring. To answer the second call while on line
with the first call, press the Page/Answer button. This puts the first call on
hold and answers the second call. To return to the first call press the Page/
Answer button again.
3.12 User Help (Keypad function key)
If programmed, users can press the User Help function key at a keypad to
broadcast Escort4580 voice prompts through the nearest intercom station.
For function key programming instructions, see your PC4020 Installation
Manual.
3.13 Music Input
The music input feature allows users to broadcast background music to all
stations which are enabled for paging. The music input feature can be
turned on or off using any keypad on the system.
For the music input to work, the incoming audio signal must be connected
to a port which is programmed for music input. See 2.5 "Music Input Wir-
ing" on page 6 and 4.1 "Port Definitions" on page 11 for more information.
firealarmresources.com
9
Advertisement
Table of Contents
