Installing the system fan
1. Place the system fan on the computer.
2. Tighten the M6xL10 screws to secure the system fan to the computer.
3. Route and connect the system fan cable to the connector on the system board.
4. Install the:
a.
optical drive
b.
hard drive assembly
c.
cooling shroud
d.
front bezel
e.
cover
5. Follow the procedure in
Coin-cell battery
Removing the coin cell battery
1. Follow the procedures in
2. Remove the:
a.
cover
b.
front bezel
c.
cooling shroud
d.
3.5-inch hard drive chassis
e.
drive cage
3. Perform the following steps to remove the coin cell battery:
a. Press the release latch away from the battery to allow the battery to pop up from the socket [1].
b. Press the coin cell battery on the open space of the socket using your finger so that the battery pops up from the socket
[1].
c. Lift the coin cell battery out of the computer [2].
50
Disassembly and reassembly
After Working Inside Your
Before working inside your
Computer.
computer.