Advertisement
TESTING INSTRUCTIONS
1.
Turn the TIME knob anti-clockwise on the minimum setting (10s). Turn the
LUX knob clockwise on the maximum setting (sun).
2.
Switch on the power; the sensor and its connected lamp will have no
signal at the beginning. After warming-up for 30sec, the sensor should
start working. If the sensor receives the induction signal, the lamp will
turn on. While there is no longer an induction signal, the load should stop
working within 10sec ± 3sec and the lamp should turn off.
3.
Turn the LUX knob anti-clockwise on the minimum setting (3). If the
ambient light is more than 3LUX, the sensor will not be functional and the
lamp will not respond. If the ambient light is less than 3LUX (darkness),
the sensor should work. Under the condition of no induction signals, the
sensor should stop 10sec ± 3sec.
NOTE: WHEN TESTING IN DAYLIGHT, THE 'LUX' SETTING SHOULD BE SET TO (SUN) IN ORDER
FOR THE PIR TO WORK PROPERLY
PROBLEMS & SOLUTIONS
PROBLEM: The load does not work
1.
Please check that the power source is connected properly
2.
Please check that the load is sufficient
3.
Please check that the settings of the working light correspond to ambient light
PROBLEM: The sensitivity is poor
1.
Please check that the e is no obstruction that could affect signals
2. Please check if the ambient temperatu e is too high
3. Please check that the installation height cor esponds to the heights
specified in these instructions
4. Please check the induction signal source is in the detection fie
5. Please check that the moving orientation is cor ect
PROBLEM: The sensor does not shut off the load automatically:
1.
Please check that there is continuous signal in the detection field
2.
Please check the time delay is set to the maximum position
3.
Please check if the power input corresponds to these instructions
Advertisement
