Cateye CC-AT100 Instruction Manual page 8

E
B
D
A
Fig.8
How the mode shifts by the MODE button
MAIN MODE
Current Speed
Current
Altitude
Current Speed
Elapsed
T
Time
Current Speed
Average
A
Speed
Current Speed
Trip
D
Distance
Fig.9
8
• Each main mode has its respective sub mode. To switch to the sub mode, hold down this button. To
switch back to the main mode from the sub mode, just press this button ordinarily. To shift from one
mode to another, it is necessary to switch back to the main mode (from the sub mode) each time.
B S/S (Start/Stop) Button (Upper Button)
C
• With each press, this button starts or stops measuring trip distance (D), elapsed time (T) and
average speed (A). During operation, the speed scale symbol or temperature scale symbol
flashes.
• In the Auto (automatic start/stop) function [when
to page 12).
C Light Button (Right Side Button)
• With each press, the display is backlit for approx. 3 seconds.
D
Set Button (Left Side Button)
This button is used for the following operations:
• For correcting the current altitude
SUB MODE
press this button in the
Trip Alt.Gain
• For shifting the altitude measuring mode
Total
x1000
press this button in the total altitude and the trip altitude gain mode ---------------- refer to page 10
Alt.Gain
• For switching on/off the Auto (automatic start/stop) function
press this button in T, D or A mode (but only in complete stop state) -------------- refer to page 12
Current Speed
• For changing the wheel circumference
12-Hour
Clock
press this button in O (total distance) mode (but only when the current speed is zero)
--------------------------------------------------------------------------------------------------------- refer to page 7
Current Speed
• For setting clock time
Max.
M
press this button in the clock time mode (but only when the current speed is zero) ---- refer to page 7
Speed
AC (All Clear) Button (on the back)
C/ F Temp.
This button erases the data stored in memory. Press this button when setting up the unit for bicycle
Total for the first time, or when irregular display occurs. After pressing this AC button, all displays illumi-
O
Distance
nate and then only the "km/h" symbol appears. The accumulated data (total distance and total alti-
Press ordinarily
tude gain) and the stored wheel circumference are not deleted by this operation. After this operation,
Hold down
only the speed scale, temperature scale and clock time must be set again, according to "Main Unit
Preparation" (refer to page 7).
symbol is on], this button does not work (refer
AT
mode (but only when the current speed is zero) ---- refer to page 10