Panasonic UF-490 Operating Instructions Manual page 35

Fax Parameter Table
No. Parameter
34 ENERGY SAVER
MODE
35 DAYLIGHT TIME
38 ACCESS CODE
39 PIN CODE ACCESS
47 REMOTE RECEPTION
48 TELEPHONE LINE
49 PSTN ACCESS CODE
51 REMOTE
DIAGNOSTIC
52 DIAGNOSTIC
PASSWORD
53 SUB-ADDRESS
PASSWORD
54 FAX FORWARD
57 COUNTRY CODE
58 LANGUAGE
Continued on the next page...
Setting
Setting
Number
1 Off To reduce the power consumption in standby, select either
Energy-Saver or Sleep mode and specify the Delay Time
2 Energy-
(1 to 120 minutes) for the machine to enter into the
Saver
selected mode.
3 Sleep
The Delay Timer setting is only available in the Energy-
Saver or Sleep Modes.
Off
Energy-Saver Mode : Saves energy by consuming less
Sleep Mode
1 Invalid Selecting whether the clock adjusts for Daylight Saving
Time automatically. The built-in clock will advance 1 hour
2 Valid
at 1:00 am on the last Sunday in March and fallback 1 hour
at 1:00 am on the last Sunday in October.
(----) Enter a 4-digit Access Code to secure the machine from
unauthorized use. (See page 75)
1 None Selecting the access method (Prefix or Suffix) to dial a
number with PIN Code. (See page 78)
2 Suffix
3 Prefix
1 Invalid Selecting whether or not the machine accepts the remote
reception command. (See page 58)
2 Valid
1 PSTN Selecting the type of line connected.
2 PBX
(----) Setting PSTN Access Code. (max. 4 digits)
1 Invalid Selecting whether or not the machine accepts to update
the firmware or Remote Diagnostics from the remote
2 Valid
station. Please ask your Panasonic Authorized Dealer for
details.
(----) Setting the password for Remote Diagnostic Mode. Please
ask your Panasonic Authorized Dealer for details.
(----) Setting a 20-digit password for secured sub-address
communication.
1 Invalid Selecting whether the machine performs Fax Forwarding
to the specified destination. (See page 80)
2 Valid
Selecting the country code when installing your machine.
Selecting the language to be shown on the display and
reports.
Customizing Your Machine
Comments
: The unit will remain in standby
mode and consume more energy
than when in Energy-Saver or
Sleep modes.
power than when in standby mode
by turning off the fuser unit after the
specified time.
: This is the lowest power state that
the machine enters after the
specified time without actually
turning off.
35