Panasonic UF-490 Operating Instructions Manual page 102

Troubleshooting
Information Codes
Info.
Code
456 •
•
494 Communication error occurred while receiving.
495 Telephone line disconnected.
501/502 Communication error occurred using the internal V.34
Modem.
540/541 Communication error occurred while transmitting.
542
543/544
550 Telephone line disconnected.
554/555 Communication error occurred while receiving.
570 A Remote Diagnostic or Firmware Update command
was
parameters are not set.
580 Sub-Address transmission to a unit that has no Sub-
Address function.
581 Sub-Address Password transmission to a unit that has
no Password Sub-Address function.
601 ADF Door was opened during ADF transmission.
623 No document loaded on the ADF.
630 Redial was not successful due to a busy line.
631 During dialling, STOP was pressed.
634 Redial was not successful due to no response from
the called station or wrong number dialed.
Note: If busy tone was not detected, the machine
638 Power failure occurred during the communication.
870 Memory overflow occurred while storing document(s)
into memory for transmission.
887 Power failure occurred.
NOTE
102
Meaning
Unit received a confidential document or was
requested to be polled of a confidential document
under any of following conditions.
1. Not enough space in memory to receive the
confidential document.
2. Confidential Mailbox is full.
3. While printing received document(s).
Unit was requested to relay a document.
received, while the
will only redial once.
1 After identifying the problem and verifying the recommended action, if the information Codes
keep reoccurring or for help on Information Codes that appear on your machine but are not
listed above, please contact your local Panasonic Authorized Dealer.
1. Print a File List and check the contents.
2. Wait until unit finishes printing.
Check with the other party.
Check with the other party.
Check with the other party.
1. Reload the document(s) and send again.
2. Check with the other party.
Check with the other party.
Check with the other party.
Check the settings of the Fax Parameters No.
Remote Diagnostic 51 and 52.
Check the remote station.
Check the remote station.
Close the ADF Door and send again.
Reload the document(s) and send again.
Reload the document(s) and send again.
Reload the document(s) and send again.
Check the telephone number and send again.
Check the power cord and plug.
Transmit document(s) without storing into
memory.
Action page
--
--
--
--
--
--
35
104
--
--
--
--
18
47
96