Table of Contents
Advertisement
TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com.tw
If you experience
Washer dryer not performing as expected (cont.)
Load not rinsed (cont.)
Load is wrinkled, twisted,
or tangled
Not cleaning or
removing stains
Possible Causes
Washer dryer not loaded as
recommended.
The load may be out of balance.
Washer dryer not loaded as
recommended.
Wash action too long for load.
Spin speed too fast for load.
The washer dryer is not unloaded
promptly.
Not choosing the right cycle for
the load being washed.
The wash water was not warm enough
to relax wrinkles.
Washer dryer not loaded as
recommended.
Not using HE detergent or using too
much HE detergent.
Hard water or high level of iron (rust) in
water.
Fabric softener dispensing
ball used.
Powdered detergent used for
slow-speed cycle.
Solution
Avoid tightly packing the washer dryer. The washer dryer will
not rinse well if tightly packed. Load with dry items only. See
the "Cycle Guide" for load size recommendations for each
cycle.
Use cycle designed for the fabrics being washed.
Add only one or two garments after washer dryer has started.
When load imbalance occurs, a washing process will start to
redistribute the load. This may lengthen the cycle time. Avoid
washing single items. Balance a single item, such as a rug or
jeans jacket, with a few extra items.
Add load loosely. Items need to move freely to reduce
wrinkling and tangling. See the "Cycle Guide" for load size
recommendations for each cycle.
Reduce tangling by mixing types of load items. Use the
recommended cycle for the type of garments being washed.
Select a lower soil level. Note that items will not be cleaned
as deeply as when using a higher soil level.
Select a slower spin speed. Note that items will be wetter
than when using a faster speed spin.
Unload the washer dryer as soon as it stops or use FanFresh
option if you will not be able to unload the washer dryer at the
end of the cycle.
Use the Delicates cycle or another cycle with a slow spin
speed
to reduce wrinkling.
If acceptable for load, use warm or hot wash water.
Add load loosely. Items need to move freely for best clean-
ing. See the "Cycle Guide" for load size recommendations for
each cycle.
Add only 1 or 2 garments after washer dryer has started.
Use only HE detergent. Always measure detergent and follow
manufacturer's directions based on load size and soil level.
You may need to install a water softener and/or iron filter.
Dispensing balls will not operate correctly with this washer
dryer.
Add liquid fabric softener to the fabric softener compartment.
Consider using liquid detergent.
®
59
Advertisement
Table of Contents
