Table of Contents
Advertisement
Description of Clean Washer with affresh
1.
The Clean Washer with affresh
clothing or other items are in the machine.
2.
If no items are detected in the machine, it will proceed with
the cycle.
If any items are detected in the machine, "rL" (remove
a.
load) will be displayed. The door will unlock. Open
machine and remove any garments from the machine
drum.
Touch POWER to clear the "rL" code.
b.
Touch and hold START/PAUSE to restart the cycle.
c.
3.
Steam models only: During the first 20 minutes of the cycle,
it will activate the steamer but the drum will not spin or fill
with water. You may see condensation on the door window
during this initial phase. If you are using an affresh
Cleaner tablet, it will not dissolve completely during the
steam phase. This is normal.
4.
After the cycle is complete, leave the door open slightly
to allow for better ventilation and drying of the machine
interior.
Cleaning the Dispensers
After using the Clean Washer with affresh
some residue buildup in the machine's dispensers.
To remove residue from the single load dispenser, remove the
drawer and wipe the surfaces with an affresh
Wipe or a damp cloth and towel dry either before or after you run
the Clean Washer with affresh
cleaner, if needed.
To remove residue from the Load & Go™ bulk dispenser, lift
the handle on the dispenser housing and pull to remove it from
the machine cabinet; then rinse the dispenser thoroughly with
running water. Wipe the outside dispenser surface with an
affresh
Machine Cleaning Wipe or a damp cloth, and towel dry.
®
Use an all-purpose surface cleaner, if needed.
Replace the dispenser in the machine cabinet and make sure that
it is correctly seated.
NOTE: Dispensers are not dishwasher-safe.
Cleaning the Outside of the All-In-One Washer Dryer
Use an affresh
Machine Cleaning Wipe or a soft, damp cloth
®
or sponge to wipe up any spills. Occasionally wipe the outside
of your machine to help keep it looking new. Use an affresh
Machine Cleaning Wipe or mild soap and water.
IMPORTANT: To avoid damaging the machine's finish, do not use
abrasive products.
Clean Washer Cycle Reminder
NOTE: Not all models have the Clean Washer with affresh
reminder light.
The Clean Washer with affresh
a wash cycle when the machine has run 30 wash cycles. This is a
reminder to run the Clean Washer with affresh
If the Clean Washer with affresh
LED will stop flashing at the end of a wash cycle after running
three more regular wash cycles. After 30 more wash cycles are
completed, the Clean Washer with affresh
the end of a wash cycle as a reminder.
38
Cycle Operation:
®
cycle will determine whether
®
®
cycle, you may find
®
®
Machine Cleaning
cycle. Use an all-purpose surface
®
LED "cL" will flash at the end of
®
cycle.
®
cycle is not performed, the
®
LED will again flash at
®
Removing The Dispenser
Single Load Dispenser Drawer
To remove:
1.
Pull dispenser drawer out until it stops.
2.
Press down on the release tab and pull straight out to
remove the dispenser.
Washer
3.
Lift off cover panel by pulling straight up.
To replace:
1.
Position cover panel back onto posts on dispenser. Apply
slight pressure on cover panel to seat it.
2.
Align edges of dispenser with guides in machine; then slide
dispenser back into slot.
®
cycle
®
Cleaning Load & Go™ Containers
It is recommended that you rinse out the Load & Go™ containers
when refilling, when changing detergent types or concentrations, or
when the machine will not be used for an extended period.
1.
Pull the dispenser drawer out until it stops.
2.
Lift out the Load & Go™ containers.
Advertisement
Table of Contents
