Advertisement
Installation of Indoor, Outdoor Unit
Sticking the installation guide map and fixing Indoor unit (Artcool Type Only)
Put an Installation Guide Map on the desired surface.
Make a hole with diameter of 6mm and depth of
30-35mm when piercing a screw point.
Drive the fore plastic anchors into drilled points.
Plastic anchors
Hang the hole of product at the upper screws.
(In this time, Remove the map)
(Falling attention)
Hanger hole
(Rear side of
product)
Check the fixed product with light power.
Drill a hole in the wall
• Drill the piping hole with a ø70mm hole core drill. Drill the piping hole at either the right or the
left with the hole slightly slanted to the outdoor side.
Standard / Artcool Deluxe type
Indoor
12 Room Air Conditioner
INSTALLATION GUIDE MAP
I N
S T
A I
I A T
I O
N
G U
I D
E M
A P
I N
S T
A L
L A
T I O
N
G U
I D
E M
A P
I N S
T A L
L A T
I O N
G U I
D E
M A P
WALL
Outdoor
Adjust level even by level guage and fix to installation
for reference on the well.
Horizontality
Drill the piercing part for connecting pipe as diameter
50mm. (In case of piercing rear surface)
Refer to No. 5 on this page when making a hole in the wall.
First, Drive the two points of the upper parts by screws
(Leave 10mm for hanging product)
Drive the lower parts after facing the hole of product
with plastic anchors, and fix completely the upper
screws.
In case of nothing wrong in the matter, connect the pipe
and the wire. (Installation manual reference)
Artcool type
WALL
Indoor
I N
S T
A L
L A
T I O
N
G U
I D
E M
A P
I N
S T
A L
L A
T I O
N
G U
Plastic anchors
Outdoor
Advertisement
