Troubleshooting - Polaris ACE 150 EFI 2019 Owner's Manual

TROUBLESHOOTING

DRIVE BELT WEAR/BURN
POSSIBLE CAUSE
Driving at low RPM or ground
speed
Insufficient warm-up at low
ambient tempera- tures
Slow/easy clutch engage-
ment
Belt slippage from water or
snow ingestion into the CVT
system
Clutch malfunction
Poor engine performance
Wrong or missing belt
Improper break-in
ENGINE DOESN'T TURN OVER
POSSIBLE CAUSE
Low battery voltage
Loose battery connections
Loose solenoid connections
Downloaded from ManualsNet.com
Drive at a higher speed.
Warm the engine at least 5 minutes. With the transmission in
neutral, apply small amount of throttle in short bursts, 5 to 7
times. The belt will become more flexible and prevent belt
burning.
Use the throttle quickly and effectively.
Dry out the PVT Prevent water from entering the PVT inlet and
outlet ducts. Inspect clutch seals for damage if repeated leaking
occurs.
Your POLARIS dealer can assist.
Check for fouled plug or foreign material in gas tank or fuel lines.
Your POLARIS dealer can assist.
Install the recommended belt.
Always break in a new belt and/or clutch.
Recharge the battery to 12.8 VDC
Check all connections and tighten
Check all connections and tighten
search engine
TROUBLESHOOTING
SOLUTION
SOLUTION
103