Reference; City Code Table - Casio 5001 Operation Manual

Operation Guide 5001
Alarm Beeper Pattern
You can select any one of three alarm beeper patterns (A, B, and C).
• To hear what the current beeper sounds like, see "To test the alarm".
To change the alarm beeper pattern
1. In the Edit Mode, use D to display the Alarm Beeper
Alarm beeper pattern
Pattern selection screen.
2. Use A to change the setting.
12/24-hour Timekeeping
You can select either 12-hour or 24-hour timekeeping.
To select 12-hour or 24-hour timekeeping
1. In the Edit Mode, use D to display the 12/24-hour
Timekeeping selection screen.
2. Press A to toggle between 12-hour (
24H
( ) timekeeping.
• With the 12-hour format, the P (PM) indicator appears
on the display for times in the range of noon to 11:59
p.m. and no indicator appears for times in the range of
midnight to 11:59 a.m.
• With the 24-hour format, times are displayed in the
range of 0:00 to 23:59, without any indicator.
• The 12-hour/24-hour timekeeping format you select is
applied in all modes.
00-second Animation
You can use this setting to turn display animation on or off. The display animation is
blink animation that is played each time the seconds reach 00 in the Timekeeping
Mode (except when a setting screen is on the display) and World Time Mode.
To turn 00-second animation on and off
1. In the Edit Mode, use D to display the 00-second
On/Off status
Animation selection screen.
2. Press A to toggle 00-second animation on (
OF
off ( ).
Setting the Analog Time
Perform the procedure below when the time indicated by the analog hands does not
match the time of the digital display.
To adjust the analog time
1. In the Edit Mode, press D to display the Analog Hand
Setting screen.
2. Hold down A until the current digital time starts to
flash, which indicates the analog setting screen.
3. Press D to advance the analog time setting by
20 seconds.
• Holding down D advances the analog time setting at
high speed.
• If you need to advance the analog time setting a long way, hold down D until the
time starts advancing at high speed, and then press B. This locks the high-
speed hand movement, so you can release the two buttons. High-speed hand
movement continues until you press any button. It will also stop automatically
after the time advances 12 hours or if an alarm (daily alarm, Hourly Time Signal,
or countdown beeper) starts to sound.
4. Press A to exit the setting screen.
• The watch automatically will adjust the minute hand slightly to match its internal
second count when you exit the setting screen.
To reset all Edit Mode settings to their initial defaults
In the Edit Mode, hold down B and D for about three seconds until
the display and the watch beeps.
• This returns all Edit Mode settings to their initial default settings.
Button Operation Tone ON
Alarm Beeper Pattern A
12/24-hour Timekeeping 12H
00-second Animation ON

Reference

This section contains more detailed and technical information about watch operation.
It also contains important precautions and notes about the various features and
functions of this watch.
Auto Return Features
• If you leave the watch in the Alarm or Edit Mode for two or three minutes without
performing any operation, it changes to the Timekeeping Mode automatically.
• If you leave a screen with flashing digits or a cursor on the display for two or three
minutes without performing any operation, the watch saves any settings you have
made up to that point and exits the setting screen automatically.
Scrolling
The B and D buttons are used in various modes and setting screens to scroll
through data on the display. In most cases, holding down these buttons scrolls at high
speed.
Initial Screens
When you enter the Timekeeping, World Time, Alarm or Edit Mode, the data you were
viewing when you last exited the mode appears first.
1 2H
) and 24-hour
World Time
• The seconds count of the World Time is synchronized with the seconds count of the
Timekeeping Mode.
• All World Time Mode times are calculated from the current Home City time in the
Timekeeping Mode using UTC time differential values.
• The UTC differential is a value that indicates the time difference between a
reference point in Greenwich, England and the time zone where a city is located.
• The letters "UTC" is the abbreviation for "Coordinated Universal Time", which is the
world-wide scientific standard of timekeeping. It is based upon carefully maintained
atomic (cesium) clocks that keep time accurately to within microseconds. Leap
seconds are added or subtracted as necessary to keep UTC in sync with the Earth's
rotation.
Illumination Precautions
An LED (light-emitting diode) illuminates the display for easy reading in the dark. In
any mode (except when a setting screen is on the display), press B to turn on
illumination for about two seconds.
• Illumination may be hard to see when viewed under direct sunlight.
ON ) and
• Illumination turns off automatically whenever an alarm sounds.
• Frequent use of illumination runs down the battery.

City Code Table

City
City
Code
PPG Pago Pago
HNL Honolulu
ANC Anchorage
YVR Vancouver
SFO San Francisco
LAX Los Angeles
DEN Denver
MEX Mexico City
CHI Chicago
MIA Miami
NYC New York
CCS Caracas
YYT St. Johns
RIO Rio De Janeiro
RAI Praia
LIS Lisbon
LON London
BCN Barcelona
PAR Paris
MIL Milan
ROM Rome
BER Berlin
ATH Athens
JNB Johannesburg
IST Istanbul
CAI Cairo
JRS Jerusalem
flashes on MOW Moscow
JED Jeddah
THR Tehran
DXB Dubai
KBL Kabul
KHI Karachi
MLE Male
DEL Delhi
DAC Dhaka
RGN Yangon
BKK Bangkok
SIN Singapore
HKG Hong Kong
BJS Beijing
SEL Seoul
TYO Tokyo
ADL Adelaide
GUM Guam
SYD Sydney
NOU Noumea
WLG Wellington
*Based on data as of December 2006.
UTC
Other major cities in same time zone
Differential
–11.0
–10.0 Papeete
–09.0 Nome
–08.0 Las Vegas, Seattle/Tacoma, Dawson City
–07.0 El Paso, Edmonton
–06.0 Winnipeg, Houston, Dallas/Fort Worth, New Orleans
–05.0 Montreal, Detroit, Boston, Panama City, Havana, Lima,
Bogota
–04.0 La Paz, Santiago, Port Of Spain
–03.5
–03.0 Sao Paulo, Buenos Aires, Brasilia, Montevideo
–01.0
+00.0 Dublin, Casablanca, Dakar, Abidjan
+01.0 Amsterdam, Algiers, Hamburg, Frankfurt, Vienna,
Stockholm, Madrid
+02.0 Helsinki, Beirut, Damascus, Cape Town
+03.0 Kuwait, Riyadh, Aden, Addis Ababa, Nairobi
+03.5 Shiraz
+04.0 Abu Dhabi, Muscat
+04.5
+05.0
+05.5 Mumbai, Kolkata, Colombo
+06.0
+06.5
+07.0 Jakarta, Phnom Penh, Hanoi, Vientiane
+08.0 Kuala Lumpur, Taipei, Manila, Perth, Ulaanbaatar
+09.0 Pyongyang
+09.5 Darwin
+10.0 Melbourne, Rabaul
+11.0 Port Vila
+12.0 Christchurch, Nadi, Nauru Island
3