G O B O I N S Ta L L At I O N - R O Tat I N G G O B O W H E E L 1 - Elation FUZE MAX SPOT User Manual

G O B O I N S TA L L AT I O N - R O TAT I N G G O B O W H E E L 1

Locate the tab of the Retention
Spring, and with a precision pick
(or similar tool), carefully press the
Retaining Spring inward to relieve the
tension. Remove the retaining spring
and carefully separate the GOBO from
the GOBO Holder.
CAUTION: TAKE CARE NOT TO SCRATCH GOBO OR GOBO HOLDER
To ensure proper Gobo orientation on the Rotating Gobo Wheel, align the Alignment Indices
before installing the Retention Spring. These indices are the notch in the Gobo Holder, the dot
on the top and bottom of the Gobo Holder Retention Tab, and the Gobo itself.
Alignment Indices
Rotate the Gear of the
Rotating Gobo Wheel until
the Gear Alignment Dot on
the bottom of the Rotating
Gobo Wheel is lined up with
the empty Gobo Holder Slot.
Install the Gobo Holder Tab
into the Gobo Holder Tab
Receptacle and press until
the Gobo Holder
springs into the empty Gobo
Holder Slot.
gently
12
Locate the Rotating
GOBO being replaced.
Carefully press
GOBO Holder down,
then pull it out and
away until it fully
clears the Fixed GOBO
Wheel.
Note that the Gobo
Holder straddles
the Rotating Gobo
Wheel in the Gobo
Holder Slot, with
the gearing
one side, and the
Retention Tab is on
the other.
the
on