Cleaning And Lubricating The Drive Chain - Yamaha Tenere 700 2021 Owner's Manual

Periodic maintenance and adjustment
(a)
1. Drive chain slack adjusting bolt
TIP
Using the alignment marks on each
7
side of the swingarm, make sure that
both drive chain slack adjusting plates
are in the same position for proper
wheel alignment.
1
(b)
1. Drive chain puller
2. Position indicator
3. Alignment marks
3. Tighten the axle nut, and then
tighten the locknuts to the speci-
fied torques.
Tightening torques:
Axle nut:
Locknut:
4. Make sure that the drive chain
slack adjusting plates are in the
same position, the drive chain
slack is correct, and the drive
chain moves smoothly.
1
3
2
105 N·m (10.5 kgf·m, 77 lb·ft)
16 N·m (1.6 kgf·m, 12 lb·ft)
7-26
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
The drive chain must be lubricated
after washing the motorcycle, riding
in the rain or riding in wet areas.
1. Clean the drive chain with a drive
chain cleaner and a small soft
brush. NOTICE: To prevent dam-
aging the O-rings, do not clean
the drive chain with steam
cleaners, high-pressure wash-
ers or inappropriate solvents.
[ECA11122]
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant. NOTICE: Do not use
engine oil or any other lubri-
EAU23027
ECA10584