Clutch Lever - Yamaha Tenere 700 2021 Owner's Manual

Instrument and control functions
Engine stop switch "
Set this switch to "
starting the engine. Set this switch
to " " (stop) to stop the engine in case
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
4
Start switch " "
Push this switch to crank the engine
with the starter. See page 6-2 for start-
ing instructions prior to starting the en-
gine.
Hazard switch " "
With the key in the "ON" position, use
this switch to turn on the hazard lights
(simultaneous flashing of all turn signal
lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
EAU12664
/ "
NOTICE
" (run) before
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12713
"SELECT" switch
This switch has the same functions as
the bottom set button of the Multi-
function meter unit.
See "Multi-function meter unit" on
page 4-4 for detailed information.
EAU12766
ECA10062

Clutch lever

EAUM4090
1. Clutch lever
To disengage the drivetrain from the
engine, such as when shifting gears,
pull the clutch lever toward to the han-
dlebar. Release the lever to engage the
clutch and transmit power to the rear
wheel.
TIP
The lever should be pulled rapidly and
released slowly for smooth shifting.
(See page 6-3.)
4-12
EAU12823
1