Table of Contents
Advertisement
10 IR IN/OUT
•
Use the supplied IR IN/OUT terminal block to connect IR OUT
terminals to compatible external IR IN source and IR IN terminals
to the output of external IR (infrared) repeater (Xantech or similar)
or IR output of compatible devices. Install the wired up IR IN/OUT
terminal block to CI 8-150's IR IN/OUT rear panel terminal.
•
With this setup, the CI 8-150 acts as an "IR-repeater" allowing the
device connected to the CI 8-150' s IR IN control or command of the
other device linked to CI 8-150's IR OUT.
11 RESET
•
Use the RESET button to manually restore CI 8-150 to its factory
default settings.
•
While at operating mode, press and hold RESET button until
Standby LED continuously flash in amber color. Release hold of
RESET button. Factory reset is completed when the continuously
flashing amber Standby LED stops and unit goes to standby mode.
12 SPEAKERS (1 - 8)
•
Connect external speaker cables to supplied SPEAKERS terminal
block ensuring that the connections match CI 8-150's SPEAKERS
terminal markings.
•
To illustrate, connect CI 8-150 SPEAKERS "1+" terminal to
corresponding "+" terminal of your external speaker and "1-"
connected to external speaker's "-" terminal. Follow the same
connection configuration when connecting other external speakers
to SPEAKERS terminals "2+" and "2-" up to "8+" and "8-".
•
After installing the external speaker cables to the supplied SPEAKER
terminal blocks, plug in the wired up SPEAKER terminal blocks to
corresponding SPEAKERS (1- 8) rear panel terminals of CI 8-150.
SAMPLE STEREO MODE SPEAKER CONNECTION FOR
SPEAKERS 1 AND 2
CI 8-150 SPEAKERS TERMINAL
EXTERNAL
SPEAKER
SPEAKERS
SPEAKERS
TERMINAL
"1 +"
External
Speaker 1
✔
"+" terminal
External
Speaker 1
"-" terminal
External
Speaker 2
"+" terminal
External
Speaker 2
"-" terminal
•
At Bridge Mode, connect the external single speaker to
corresponding CI 8-150 SPEAKERS terminals marked "1+" and "2+"
ensuring that "1+" is connected to the external speaker's "+" terminal
and "2+" connected to the external speaker's "-" terminal (This is
sample BRIDGE mode connection for SPEAKERS 1 and 2. The same
BRIDGE mode connection configuration applies for the rest of the
SPEAKERS terminal blocks).
•
Bridge Mode connection can be enabled or disabled via the INPUT/
OUTPUT menu of the web-based CI 8-150 User Interface.
SPEAKERS"2
SPEAKERS"2
"1 -"
+"
-"
✔
✔
✔
IDENTIFICATION OF CONTROLS
SAMPLE BRIDGE MODE SPEAKER CONNECTION FOR
SPEAKERS 1 AND 2
CI 8-150 SPEAKERS TERMINAL
EXTERNAL
SPEAKER
SPEAKERS
SPEAKERS
TERMINAL
"1 +"
Single external
Speaker "+"
✔
terminal
Single external
Speaker "-"
terminal
13 AC MAINS INPUT
•
The CI 8-150 comes supplied with two separate AC power cords.
Select the AC power cord appropriate for your region.
•
Before connecting the AC power cord plug to the mains power
source, ensure that it is firmly connected to CI 8-150's AC Mains
input socket first.
•
Always disconnect the AC power plug from the mains power source
first, before disconnecting the other end of the AC power plug from
the CI 8-150's AC Mains input socket.
SPEAKERS"2
SPEAKERS"2
"1 -"
+"
-"
✔
7
Advertisement
Table of Contents
