HP 525 Quick Start Manual page 3

Status LEDs
Table 1 LED description
Status
Flashing green at 1
Hz
Slowly pulsing green
Flashing blue at
0.25 Hz
Flashing blue at 4
Hz
Slowly pulsing blue
Steady orange
Flashing orange at 1
Hz
Flashing orange at
8 Hz
Cycle through two
green pulses then
two blue pulses
Powering the HP 525
The AP can be powered by:
A 10/100 or 10/100/1000 PoE-enabled switch. Various PoE-enabled
•
switches are available from HP.
A PoE power injector, such as J9407B.
•
An HP 48 volt power adapter, JD055B.
•
Description
The AP is booting.
NOTE:
When the AP operates as a fit AP, it is always in this state
before it is registered to an AC.
Connections are present on the 2.4 GHz radios.
The AP has been booted and has registered to the AC. It is
in standby state (no client is associated with the AP).
The AP is upgrading its system software image.
Connections are present on the 5 GHz radios.
An initialization exception has occurred to the AP.
The AP cannot detect any radio interface.
An Ethernet port or radio interface is operating incorrectly.
Connections are present on both the 2.4 GHz and 5 GHz
radios.
3