Table of Contents
Advertisement
Appendix P
P.1
Notes on Using the Bezel Option (OT-BU30)
1)
A bezel option (OT-BU30) can be used with this printer.
2)
If using the bezel option (OT-BU30), the printer's paper can only be ejected in the front direction.
3)
Confirm that there is enough space even when the printer's roll paper cover is open.
P.2
Installing the Bezel Option (OT-BU30)
Step 1:
Check that the printer's power is off, then open the roll paper cover.
Step 2:
zRemove the screws that fasten the case containing the indicators.
Step 3:
Remove the case containing the indicators.
Step 4:
Install the case containing the indicators on top of the bezel option.
Note:
The sharp edge can cut your fingers.
Install the case without touching the sharp edge.
Step 5:
Close the roll paper cover.
Step 6:
Clean the roll paper cover.
Step 7:
Peel off the backing from the tape attached to the part at the bottom of the bezel option. Then attach it
such that the side of the bezel option fits in the ribs of the roll paper cover's paper discharge port.
BEZEL OPTION (OT-BU30)
Sharp edge
Figure P.1
Figure P.2
71
Advertisement
Table of Contents
