Table of Contents Alva Duo ............................................. Introduction ............................................What's included with the Alva Duo? ....................................Front panel controls ......................................... Rear panel ............................................Getting connected ..........................................Auto power down (APD) ........................................What is the difference between a moving magnet cartridge and a moving coil cartridge? ................
This guide is designed to make installing and using this product as easy as possible. Information in this document has been carefully checked for accuracy at the time of printing; however, Cambridge Audio’s policy is one of continuous improvement, therefore design and specifications are subject to change without prior notice.
2. Safety Guide. 3. Quick Start Guide. 4. UK power cord (5A fused) (Depending on which country the Alva Duo was purchased in), EU power cord (Depending on which country the Alva Duo was purchased in), CU power cord (Depending on which country the Alva Duo was purchased in)
Front panel controls Last updated: June 28, 2022 03:30. Revision #4975 1. Standby/On - Switches the unit between Standby mode (indicated by dim LED) and On (indicated by bright LED). Standby mode is a low power mode where the power consumption is less than 0.5 Watts. 2.
Rear panel Last updated: June 28, 2022 03:30. Revision #4976 1. AC Power Socket. 2. Signal Output Sockets - RCA connections used to connect to a line-level input. Note: Do not connect to a phono-level input. 3. Balance Control - Used to make fine adjustments to the relative output levels of the left and right channels. In the central position the output from each channel is equal.
Attach the mains power lead securely to the Alva Duo and power on the unit. Using the cartridge type selection switch, set the Alva Duo to MM for use with a moving magnet cartridge, or MC for use with a moving coil.
Last updated: June 28, 2022 03:30. Revision #4978 The Alva Duo comes set up with Auto Power Down (APD) enabled and will automatically switch to standby mode after 20 minutes of inactivity. To disable Auto Power Down (APD): If you wish to disable the APD function, then press and hold the power button for 5 seconds when in standby.
What is the difference between a moving magnet cartridge and a moving coil cartridge? Last updated: June 28, 2022 03:30. Revision #4979 The cartridge mounted to the tonearm of your turntable uses a small stylus tip, made of diamond, to convert the information held within the groove of a record to a signal which can then be amplified for listening.
• Check that the Alva Duo balance control is set centrally. There is a loud buzz or hum. • Check that the ground lead (if present) is securely connected to both the turntable and Alva Duo. • Ensure all interconnects are secure and intact.