18. STARTING SYSTEM
3. Start Motor
3.1. Inspection
Connect the start motor cable directly to the
battery positive terminal.
If the start motor does not turn, the starter
motor is faulty.
3.2. Removal
Rubber cap
Cable
Turn the ignition switch turned to "OFF"
Release the rubber cap and remove the
terminal screw to disconnect the cable from
the start motor.
Remove the two mounting bolts then
remove the start motor.
3.3. Installation
Coat a new O-ring with engine oil and install
it into the start motor groove.
Install the starter motor into the crankcase.
Install the two mounting bolts securely.
TORQUE: 0.7~1.1 kgf-m
Connect the cable to motor terminal with the
terminal screw and tighten it securely.
18-4