Residual Risks - Black & Decker HLVC315B11 Quick Start Manual

Residual risks

Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.
Even with the application of the
relevant safety regulations and the
implementation of safety devices, certain
residual risks can not be avoided. These
include:
Injuries caused by touching any
u
moving parts.
Injuries caused by touching any hot
u
parts.
Injuries caused when changing any
u
parts or accessories.
Injuries caused by prolonged use
u
of the appliance. When using any
appliance for prolonged periods
ensure you take regular breaks.
Health hazards caused by breathing
u
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
Batteries and chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not expose the battery to heat.
u
Do not store in locations where the
u
temperature may exceed 40°C.
Charge only at ambient temperatures
u
between 10°C and 40°C.
Charge only using the charger
u
provided with the appliance/tool.
(Original instructions)
Using the wrong charger could result
in an electric shock or overheating of
the battery.
When disposing of batteries, follow
u
the instructions given in the section
"Protecting the environment".
Do not damage/deform the battery
u
pack either by puncture or impact, as
this may create a risk of injury and fire.
Do not charge damaged batteries.
u
Under extreme conditions, battery
u
leakage may occur. When you notice
liquid on the batteries carefully wipe
the liquid off using a cloth. Avoid skin
contact.
In case of skin or eye contact, follow
u
the instructions below.
Warning! The battery fluid may cause
personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a
specific voltage.
Always check that the mains voltage
corresponds to the voltage on the rating
plate and the information in the technical
data table.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your BLACK+DECKER charger
u
only to charge the battery in the
appliance/tool with which it was
supplied.
ENGLISH
5