Download Print this page

TP-Link tapo Quick Start Manual

Contact sensor

Hide thumbs Also See for tapo:

Download this manual

Meet Your Contact Sensor

Know when doors and windows are opened or closed and send you intant alerts via the Tapo app.

Quick Start Guide

Magnet

Contact

Sensor

LED Light

Sensor

Reset Button

Magnet

Battery Compartment

Alignment

Remove the battery

Mark

insulation tab before use.

Before You Start

1. Power Up Your Sensor

A Tapo Hub is required. Make sure your

a. Use a screwdriver to tilt the clip (not pry) and

Tapo Hub is successfully added via the

slide the cover down by hand.

Tapo app.

2. Set Up Your Sensor

b. Remove the battery insulation tab to power

Open the Tapo app, tap the

up your Tapo device.

app, and select your model. Follow app

instructions to complete the setup.

button in the

Page 1 2. Set Up Your Sensor Meet Your Contact Sensor Know when doors and windows are opened or closed and send you intant alerts via the Tapo app. A Tapo Hub is required. Make sure your a. Use a screwdriver to tilt the clip (not pry) and b.
Page 2 This product contains a coin / button cell battery. If the coin / button cell affix it yet). Place the magnet near the edge sure the Tapo app shows the sensor is open magnet. than 0.39 inches (10 mm) between them.
Page 3 FCC RF Radiation Exposure Statement: Product Name: Tapo Smart Contact Sensor is encouraged to try to correct the interference by one or more of the following measures:...