Sony Handycam DCR-HC30 Operation Manual page 17

After charging the battery
The CHG (charge) lamp turns off when the
battery is fully charged. Disconnect the AC
Adaptor from the DC IN jack.
To remove the battery pack
BATT (battery)
release button
battery pack
1
Set the POWER switch to OFF (CHG).
2
Slide the battery pack out in the direction
of the arrow while pressing the BATT
(battery) release button down.
b Note
• If you do not use the battery pack for a long time, use
up the battery pack completely before storing it. See
page 129 about storage of the battery pack.
To check the remaining battery – Battery
Info
DSPL/BATT INFO
You can check the battery's current charge level
and its current remaining recording time both
during charging or when the power is turned off.
POWER switch
POWER switch
1
Set the POWER switch to OFF (CHG).
2
Open the LCD panel.
3
Press DSPL/BATT INFO.
The battery information appears for about 7
seconds.
Keep the button pressed to view it for about
20 seconds.
BATTERY INFO
BATTERY CHARGE LEVEL
0% 50%
REC TIME AVAILABLE
LCD SCREEN
VIEWFINDER
A Battery charge level: Displays
approximate remaining amount of
power left in the battery pack.
B Approximate possible recording time
using the LCD panel.
C Approximate possible recording time
using the viewfinder.
Charging time
Approximate number of minutes required when
you fully charge a fully discharged battery pack
at 25°C (77°F). (10 – 30°C (50 – 86°F)
recommended.)
Battery pack
NP-FP50 (supplied)
NP-FP70
NP-FP90
100%
: 76 min
: 85 min
125
155
220
,continued
Getting started
17