Sirius Satellite Radio PowerConnect XMP3IVKUG0210 User Manual page 30

Vehicle Installation
Route the cable:
• Sedan/Coupe with the Antenna Placed at the Rear of the Roof:
1 . Feed the antenna cable from the antenna underneath the rubber
molding around the rear window . Use a blunt plastic putty knife or
similar blunt tool to lift the rubber molding around the rear window
and tuck the antenna cable underneath the molding . Route the
antenna cable around and down the window to the lowest point . If
your rear window does not have rubber molding, we recommend
consulting a professional installer .
2 . Route the antenna cable out of the window molding and into the
rubber weather stripping around the trunk opening . Lift the weather
stripping from the opening and tuck the cable inside it, then replace
the weather stripping . To avoid sharp bends in the cable, run the
cable inside the weather stripping for a few inches, then remove the
cable from the weather stripping inside the trunk . Keep the cable
away from hinges, gears,
etc ., that could damage it .
3 . Route the cable out
from the rubber weather
stripping and along the
trunk wall . Continue
routing the cable into
the vehicle cabin through
a conduit or along an
existing wiring harness .
30