Connection Of The Speaker Cables - Panasonic SB-WA330GN Service Manual

If this occurs, follow the procedure outlines below:
1. Turn off the power.
2. Determine the cause of the problem and correct it.
3. Turn on the power once again after one minute.
Note :
When the protection circuitry functions, the unit will not operate unless the power is first turned
off and then on again.

5. Connection of the Speaker Cables

- Be sure to connect speaker cables before connecting the AC
power supply cord.
- The load impedance of any speaker used with this unit must be 4
.
- Be sure to connect the cable from the right speaker to the right
terminal and the cable from the left speaker to the left terminal.
1. Strip off the outer covering, and twist the center conductor. Make
sure the bare ends of the wires are not unravelled. (If they are,
twist them tight again.)
2. Insert the wire to the rear panel of the unit and close the lever.
Notes :
- To prevent damage to circuitry, never short-circuit positive (+) and
negative (-) speaker wires.
- Be sure to connect only positive (red) wires to positive (+)