Power Control; Power Management; No Signal Off; No Operation Off - Sharp LC 19SK25U Operation Manual

Basic adjustment settings

Power Control

Power control setting allows you to save energy.

No signal off

When set to "Enable", the power will automatically shut
down if there is no signal for 15 minutes.
Press MENU to display the MENU screen, and
1
then press c / d to select "Power Control".
Press a / b to select "No Signal Off", and then
2
press ENTER.
Press a / b to select "Enable", and then press
3
ENTER.
Enable
Disable
• Five minutes before the power shuts down, the
remaining time displays every minute.
Press MENU to exit.
4
• "Disable" is the factory preset value.
• When a TV program fi nishes, this function may not operate.

No operation off

The power will automatically shut down if there is no
operation for 30 minutes or 3 hours after setting.
Press MENU to display the MENU screen, and
1
then press c / d to select "Power Control".
Press a / b to select "No Operation Off", and
2
then press ENTER.
Press a / b to select "30min" or "3Hour", and
3
then press ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
Press MENU to exit.
4
• "Disable" is the factory preset value.
30

Power Management

You can set the TV to automatically power off when no
image is displayed on PC.
Press MENU and the MENU screen displays.
1
Press c/d to select "Power Control", and
2
then press ENTER.
• Power control menu displays.
Press a/b to select "Power Management",
3
and then press ENTER.
Press a/b to select "Mode 1" or "Mode 2",
4
and then press ENTER.
Off
Mode 1
Mode 2
Selected item
Off • No power management
• Factory preset value.
Mode 1 • If no signal inputs for approximately 8
minutes, the power shuts down.
• Even if you start using the PC and the
signal inputs again, the TV stays off.
• The TV turns on again by pressing
POWER. (See page 17.)
Mode 2 • If no signal inputs for approximately 8
seconds, the power shuts down.
• When you start using the PC and the
signal inputs again, the TV turns on.
• The TV turns on again by pressing
POWER. (See page 17.)
NOTE
• If you turn off the power by disconnecting AC cord when
setting "Mode 2" in power management, the TV may not
function properly after turning the power on again. In such
case, press POWER on the remote control unit.
• Pressing POWER on the display will have the same result.
• In Mode1, fi ve minutes before the preset of time expires,
the remaining time displays each minute.
Description