Miele Triflex HX1R Operating Instructions Manual page 11


Charging with a self-sufficient or non-mains synchronous energy
supply system (e.g. isolated networks, back-up systems) is possible.
A requirement for charging is that the energy supply system com-
plies with all current local and national requirements that apply to
stand-alone, solar and/or battery systems.
The protective measures provided in the domestic installation and in
this Miele product must also be assured in their function and opera-
tion in isolated operation or in non-mains synchronous operation, or
replaced with equivalent measures in the installation.

Charge and use the battery at an ambient temperature between
0 °C and 45 °C.
Using the battery outside of this ambient temperature range will limit
its performance.

Stop using the AP01/AP02/AP03 battery immediately if you notice
an unusual smell from it, if liquid is leaking from it, if it is significantly
overheating or if it is discoloured or deformed. Dispose of the AP01/
AP02/AP03 battery immediately (see safety notice "Disposing of the
AP01/AP02/AP03 battery" at the end of this chapter as well as
"Caring for the environment – Disposing of old batteries").

Batteries will deplete over time. They can then leak corrosive flu-
ids. Avoid contact with the eyes and skin. In the event of contact,
rinse thoroughly with water and seek medical advice.

To deal with leaking batteries, refer to the Safety Data Sheet (con-
tact Miele to request a copy).

The AP01/AP02/AP03 lithium-ion battery is subject to the danger-
ous goods legislation. The user is permitted to transport the AP01/
AP02/AP03 battery by road, but may be subject to further require-
ments. Only send AP01/AP02/AP03 batteries that are undamaged
and have been fully run down. Insulate the metal contacts with ad-
hesive tape to prevent short circuits. Pack the AP01/AP02/AP03 bat-
tery in such a way that it is not able to move around inside the pack-
aging.
Warning and Safety instructions
11