Mp3/Wma Disc Operation - Sanyo DC-MX31 Instruction Manual

If necessary, press the PLAY/PAUSE
select a track to play from the disc.
Note: In program mode, Random playback can't be selected.
Clear play mode
Press the PLAY MODE button fourth times to cancel the play mode and normal playback will
resume.
Programmed Playback
It is possible to program a selection of up to 20 tracks for playback.
1. After loading a disc, Press the PROGRAM button in stop mode. PGM and
P01 will show in the display.
2. Press the
track number.
3. Press the PROGRAM button to confirm the first programmed track. P02
now shows in the display
4. Repeat steps 2 and 3 to store up to 20 tracks.
5. When programming is complete, press the
begin playback of the programmed tracks.
Clear Program (Resume Normal Playback)
Press the STOP button twice during playback, or open the CD door, or change to another mode to
erase the programmed tracks.
Normal Playback
After loading a MP3/WMA, press
and current track number will indicate in the display.
Pause control
To pause temporarily during MP3 playback, press the
will pause. Press the
Skip track
The procedure for skipping tracks is the same as previously described in the CD operation section
of this manual.
Skip ALBUM
In stop mode or during playback, press the FOLDER+ button repeatedly on the main unit or
FOLDER+ or FOLDER- buttons on the remote control to skip to next or previous folder, playback will
begin at the first track in the selected folder.
PLAY MODE CONTROL
There are four play modes. Press the PLAY MODE once to active RPT mode, press the PLAY
MODE twice to active RPT ALBUM mode, Press third time to active RPT ALL mode, press the PLAY
or buttons repeatedly to select the desired

MP3/WMA DISC OPERATION

PLAY/PAUSE button to start playback. The MP3 or WMA
PLAY/PAUSE button again to resume playback.
button to begin playback. The player will randomly
PLAY/PAUSE button to
PLAY/PAUSE button. The disc playback
9