Setting Up The Refrigerator; Removing The Refrigerator Doors; Tools You Will Need - Samsung RFG297AAWP User Manual

sEttinG uP tHE REFRiGERAtoR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the
Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly
chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can
store food and drinks in the Refrigerator after the temperature is sufficiently cool.
Check the accessory list below.
Water filter Hex wrench
(DA29-00003G) (DA80-00002C)

REMoVinG tHE REFRiGERAtoR DooRs

If the Refrigerator is too large to pass through your doorway easily, you can remove the refrigerator doors.

tools you will need

Philips screwdriver Flat-blade screwdriver
Disassemble the Refrigerator doors
1. With the door opened, remove the Hinge Cover
cap ( )with a Flat head screwdriver, and close
1
the door.
Remove the 3 screws holding down the Hinge
Cover and remove the Hinge Cover (
Fastener Compression fitting
(DA60-00143B) (DA62-00305A)
Wrench
).
2
Compression nut
(DA74-00070B)
Pliers Allen wrench(3/16")
1
2
Setting Up _9