Assembly Instructions - Casio Celviano AP-38 User Manual

Assembly Instructions

Caution
• Take particular care to avoid injury when installing
legs and pedals, and when mounting the keyboard
onto the stand.
• When assembling, make sure that the sliding keyboard
cover of the digital piano body is completely closed. If
the cover is left open during assembly, it may close
suddenly causing the fingers to be pinched between
the digital piano body and cover.
IMPORTANT!
• Be sure to assemble the stand on a flat surface.
• This stand does not include any of the tools required to
assemble it. You should have a large Phillips head (+)
screwdriver on hand for assembly.
Figure 1
B
A
• Check the items that come with the unit to make sure that
everything shown in Figure 1 (A through M) is included.
All screws are in a plastic bag inside of the packing
cardboard.
Figure 2
1
• Before starting actual assembly of the stand, undo the clip
at location 1 (Figure 2) where the pedal cable comes out
the back of crosspiece D.
428A-E-039A
AP38_e_34-39.p65
E
x2
C
F
x4
G
x2
H
x1
I
x4
J
x26
K
x2
L
x2
D
M
x4
2
35
1 Assembling the stand
Refer to Figures 3, 4 and 5 as you assemble the stand according
to the following procedure.
Figure 3
M
G
I
A J
D
E
J
J
H
3
Side upright
Bottom
E
4
5
1. Attach E and F brackets to side uprights A and B using
the J screws (Figure 3).
• When attaching the F bracket to the side upright B, slip
a K clip onto the J screw before screwing the J screw
into the upright at point 3.
2. Attach angle brackets G to side uprights A and B using
the four J screws (Figure 3).
3. Install height adjustment screw H into hole 4 located in
the center of the back of crosspiece D (Figure 3).
4. Attach side uprights A and B to crosspiece D using the
four I screws (Figure 3).
• When joining the two pieces marked 5, the metal pieces
E on the insides of side uprights A and B should fit
into the slots at the ends of crosspiece D. Make sure the
metal pieces enter into the slots as far as they will go. If
the pieces are not positioned correctly, the nuts built into
crosspiece D will not seat properly with the I screws.
This can result in stripping of the threads and free turning
of nuts.
02.6.12, 15:55
F
J
J K
C
F
M
I
J
B
G
E
Crosspiece
E-35