Table of Contents
Advertisement
10.6 Accessing Basic Menu Items
In the Main Menu screen, you can view the boiler's operating
conditions, configure the central heating and DHW
temperatures, and review error history. Press the Menu button
(
) to enter the Main Menu screen.
10.6.1 Viewing Basic Information
To view information about the boiler, press the Menu button
(
), and then select "1. Status Information".
Press the Up button (
) or the Down button (
between the information items. Press the OK button (
select an item and view the information.
Press the Back button (
Item
1. Operation State
2. Heat Capacity
3. CH Set Temp
4. DHW Set Temp
5. Supply Temp
6. Return Temp
7. Outdoor Temp
44
Operating the Boiler
) to switch
) to exit information view mode.
Description
Current Operation State
Heat capacity (%)
Central heating set temperature
(°C)
DHW set temperature (°C)
Heating supply temperature
(°C)
Boiler return temperature (°C)
Outdoor temperature (°C)
Item
8. Inlet Temp
9. DHW Temp
10. Water Flow
11. Water Press
12. Flame Value
13. Fan Target RPM
14. Fan Current RPM
15. Fan Target APS
16. Fan Current APS
17. Exhaust Temp
18. OTC ON/OFF
19. K-Factor Set Value
20. Model
21. Type
22. Gas
23. Main F/W Ver
24. Panel F/W Ver
The fan motor controls the APS, so the fan target
Note
speed (Fan Target RPM) is only for your reference.
) to
Description
Inlet temperature (°C)
DHW temperature (°C)
Water flow rate (LPM)
Water pressure (bar)
Flame detector AD value
Flame On: 8bit AD values
●
equal to or lower than 70
Flame Off: 8bit AD values
●
equal to or higher than 175
Fan target speed (RPM)
Fan speed (RPM)
Fan target speed (APS)
Fan speed (APS)
Exhaust temperature (°C)
OTC status (Enabled/Disable)
K-Factor set value
Model type
Boiler type (Combi/System)
Fuel Type (LNG G20/LPG G30/
LPG G31)
Main firmware version
Panel firmware version
Advertisement
Table of Contents
