Related Manuals for NAL 9602-LP
Summary of Contents for NAL 9602-LP
- Page 1 451-92750-001A 9602-LP Quick Start Guide Version A April 15, 2022 Copyright © 2021 by NAL Research Corporation 11100 Endeavor Ct., Suite 300 Manassas, Virginia 20109 USA Phone: 703-392-1136 Email: contact@nalresearch.com...
- Page 2 Product (including hardware, software and/or firmware) and/or the Iridium satellite to the fullest extent these damages may be disclaimed by law and whether advised of the possibilities of such damages. NAL Research is not liable for any claim made by a third party or made by you for a third party.
- Page 3 Description 1.4.5 05/30/2014 Initial version 07/30/2021 Updated to new template 04/20/2022 Formal release EFERENCE OCUMENTS The latest revisions of the NAL documents are available from the NAL Research website at https://www.nalresearch.com/support/documentation-downloads/. Reference Title Revision/Date Version A, 9602-LP User Guide 03/28/2022...
-
Page 4: Table Of Contents
Figure 8: SMA Female 50-ohm Antenna Connector (GPS) ............12 Figure 9: Model SAF7352-IG Antenna ..................12 ABLE OF ABLES Table 1: Pin Assignments for the 9602-LP Multi-Interface Connector ........... 7 Table 2: Description of LED States ....................10 Document Number: 451-92750-001A 4 of 15... - Page 5 9602-LP Quick Start Guide Version A CRONYM AC .......alternating current AT .......Two-letter sequence starting a string of terminal commands. The AT is intended to get the terminal’s attention prior to executing a command. dB .......decibel DC .......direct current DoD ......Department of Defense EMSS ......Enhanced Mobile Satellite Services...
-
Page 6: Introduction
When a Data Terminal Equipment (DTE) is connected to the 9602-LP with SatTerm software installed (or any terminal emulator software), the DTE can be used to set up the operating parameters of the 9602-LP via a serial connection. A DTE can be a desktop computer, a laptop computer, or a tablet. -
Page 7: Device Description
ULTI INTERFACE ONNECTOR The multi-interface connector on model 9602-LP is a standard male 15-pin miniature D-Sub type (DB-15) connector, as shown in Figure 1. Figure 2: Multi-Interface Connector The connector comprises four interfaces with the pin assignments shown in Table 1. These interfaces include: ... -
Page 8: Figure 3: Model Hrc-24-12 Data/Power Cable Assembly
Model HRC-24-12 is a data/power cable assembly (see Figure 3) designed to work with the 9602-LP tracker. The HRC-24-12 has a three-foot RS-232 cable for connection onto a computer and three wires for DC power inputs to a 9602-LP. Model HRC-24-12 is available on the NAL website (www.nalresearch.com). -
Page 9: Emergency Button
Under the default configuration, you can trigger Emergency Tracking at any time with a quick press and release of the Emergency button (momentary switch). See Figure 4. Once enabled, holding the Emergency button longer than three seconds takes the 9602-LP out of Emergency Tracking. When Emergency Tracking is active, the Emergency LED illuminates. -
Page 10: Table 2: Description Of Led States
Input is activated Watch closely for the LED because it can briefly stay on. The 9602-LP is shipped with all LEDs set to ACTIVE. The LEDs can be disabled to reduce power consumption. Document Number: 451-92750-001A 10 of 15... -
Page 11: Antennas
The 9602-LP uses a single SMA female 50-ohm antenna connector for both transmission and reception of the Iridium signal, as shown in Figure 6. NAL Research offers several types of antennas for use with the 9602-LP. For low-cost and applications where small form-factor and light weight are required, NAL Research highly recommends model SYN7391-C, as shown in Figure 7. -
Page 12: Gps Antenna Connector
NTENNA ONNECTOR The 9602-LP tracker uses a SubMiniature Version A (SMA) female connector for the GPS antenna, as shown in Figure 8. For low-cost and applications where small form-factor and light- weight are required, NAL Research highly recommends model SAF7352-IG, as shown in Figure... -
Page 13: Configuring The 9602-Lp
Guide” [2] for details. 3. Apply the appropriate DC power to the 9602-LP. The 9602-LP defaults to power on when DC power is first applied. It is not necessary to push the ON/OFF button. An NAL Research message appears along with the firmware version to indicate proper serial communications and power input. - Page 14 EMSS SBD service before testing or field use. Accessing the DoD EMSS Gateway is not authorized until the 9602-LP is provisioned. Unauthorized attempts to access the DoD EMSS Gateway will result in immediate disabling of the offending device, which must then be returned to NAL Research for repair.
-
Page 15: Technical Support
For technical support, please contact us at: Phone: 703-392-1136, x203 Fax: 703-392-6795 Email: support@nalresearch.com Technical documents are also available to download on NAL Research’s website www.nalresearch.com in the Support > Documentation & Downloads section. Document Number: 451-92750-001A 15 of 15...