Table of Contents
Advertisement
Problem
Washing not well spun.
Residual water still vis-
ible in the drum.
E20
Fault code
ap-
pears. The indicator
RINSE flashes.
The main door cannot
be opened while the
appliance is turned on.
Washing detergent
residues form in the
washing detergent
drawer.
Possible Cause
Drainage hose bent.
Maximum pump head (outlet
head 1m from unit's floor
surface) exceeded.
Solution pump blocked.
If a siphon is connected: Si-
phon blocked.
The main door is locked be-
cause of a high water level or
a high temperature. The dis-
play DOOR is not lit.
Power failure!
(All displays have gone off.)
For safety reasons the door
remains locked for 4 to
5 minutes.
Water tap not fully opened.
Filter in the screw connec-
tion of the intake hose on
the water tap or on the unit
is blocked.
Operating Instructions
Remedy
Remove the bend.
Consult Customer Service.
They can supply a retrofit kit
as a special accessory for de-
livery heads of more than
1m.
Switch off the unit and pull
out the mains plug. Clean
the solution pump.
Clean the siphon.
Wait until the display DOOR
lights up green.
Should it nevertheless be
necessary to open the main
door:
Turn the programme knob to
OFF; turn the programme
knob to PUMP OUT. Press
button START/PAUSE. The
main door can be opened af-
ter the water has been
pumped out.
If water can be seen through
the window in the door, first
carry out emergency empty-
ing (see section "Carrying out
Emergency Emptying Opera-
tion").
After approx. 4 to 5 minutes
the door can be opened
again by pulling the handle.
Open the water tap fully.
Close the water tap. Unscrew
the intake hose from the wa-
ter tap and from the unit.
Clean the filter.
35
Hide quick links:
Advertisement
Table of Contents
