Samsung VPL500 Service Manual page 62

b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the "FADE(MODE UP)" or
"BLC(MODE DOWN)" button of FUNCTION
so as to select the address 01.
e. Press the "TILTLE(DATA DOWN)/ DSE(DATA
UP)" so that OSD shows" "ERR:XX EVR: XX"
"XX" is different dependent on the model as
below.
Model Name Addressed code
VP-L500 02
VP-L520 02
VP-L530 33
VP-L530B 33
VP-L550 77
f. Be sure to press the "PROGRAM AE(CON-
FIRM)" button on FUNCTION to memorize set-
ting.
g. Reset the power source so as to fix the new data
to the camcorder's EEPROM.
2-2. Model Code 1
a. Preparation
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the "FADE(MODE UP)" or
"BLC(MODE DOWN)" button of FUNCTION
so as to select the address 02.
e. Press the "TITLE(DATA DOWN)/ DSE(DATA
UP)" so that OSD shows" "ERR:XX EVR: XX"
"XX" is different dependent on the model as
below.
Model Name Addressed code
VP-L500 A4
VP-L520 E4
VP-L530 E4
VP-L530B E4
VP-L550 E4
f. Be sure to press the "PROGRAM AE(CON-
FIRM)" button on FUNCTION to memorize set-
ting.
g. Reset the power source so as to fix the new data
to the camcorder's EEPROM.
Samsung Electronics
Model Name Addressed code
SCL500 02
SCL520 02
SCL530 73
SCL550 77
Model Name Addressed code
SCL500 A2
SCL520 A4
SCL530 E4
SCL550 E4
2-3. Head Switching Point
: This adjustment is performed after the
replacement of deck mechanism.
• Without this adjustment, there will be a noise
in playback picture.
a. Preparations
STANDARD COLOR BAR TAPE
RECORDED WITH SP SPEED
TAPE
EQUIPMENT POWER SOURCE
OTHER NONE
TEST POINT NONE
ADDRESS 03
NAME HD SWP
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the "FADE(MODE UP)" or "BLC(MODE
DOWN)" button of FUNCTION so as to select
the address 03.
e. Insert the Standard Color Bar Tape and press
the "PLAY" button.
Note : If there is no video out, when you pressed
the "PLAY" button, you can not adjust the
Head Switching Point.
It may be caused by maladjusted VIDEO
block.
In this case, adjust the VIDEO block before
the Head Switching Point.
VIDEO block adjustments are 2-3~2-11.
f. The data of Head Switch is set to 7.2H~7.7H
automatically.
03.HD SW P
EPR : XX
g. Be sure to press the "PROGRAM AE(CON-
FIRM)" button on FUNCTION to memorize set-
ting.
h. Reset the power source so as to fix the new data
to the camcorder's EEPROM.
Alignment and Adjustment
7.5H
EVR : YY
4-43