Advertisement
Setup-General
Connecting
Your Monitor
Installing the
Monitor Driver
Installing VESA
compliant mounting
Connect the power cord for your monitor to the power port on the back of the monitor. Plug the
1.
power cord for the monitor into a nearby outlet.
2-1. Using the D-sub (Analog) connector on the video card.
Connect the signal cable to the 15-pin, D-sub connector on the back of your monitor.
2-2. Using the DVI (Digital) connector on the video card.
Connect the DVI Cable to the DVI Port on the back of your Monitor.
Connected to a Macintosh.
3.
Connect the monitor to the Macintosh computer using the D-SUB connection cable.
In the case of an old model Macintosh, you need to connect the monitor using a special Mac
4.
adaptor.
Turn on your computer and monitor. If your monitor displays an image, installation is complete.
5.
You may get a blank screen depending on the type of video card you are using, if you connect
simultaneously both the D-sub and DVI cables to one computer.
If you connect properly your monitor using the DVI connector but get a blank or fuzzy screen,
check to see if the monitor status is set to analogue. Press Power Button to have the monitor
double-check the input signal source.
English > Main > Setup > Connecting Your Monitor
Advertisement
