Using Tracks To Record And Mix Parts - Casio CTK-4000 User Manual

8.
4
Press twice to exit the recorder mode.
Disappears
• The flashing on the screen shown in step 3 becomes
faster when remaining recorder memory capacity
becomes less than 100 notes.
• Total recorder memory capacity is approximately
12,000 notes. Recording will stop automatically when
there is no more unused recorder memory remaining.
4
• Each press of cycles through the settings shown
below. You can listen to the recorded data as many
times as you like by pressing
standby.
Playback
Recorder Off
Disappears
■ To delete recorded data
After step 3 of the above procedure, do hold down
pressing any keyboard key) until the message "Tr.Del?"
appears on the display. Press [+] (YES) to delete the data, or
[–] (NO) to cancel the delete operation.
• Turning off the Digital Keyboard while recording is in
progress will cause any data in recorder memory to be
deleted.
• A new recording replaces (deletes) previously recorded
contents.
■ Maintaining Data in Recorder Memory
After you save data in recorder memory, it will remain there as
long as power is supplied to the keyboard. However, if you
disconnect the AC adaptor when there are no batteries
loaded, data in recorder memory will be deleted.
Tips for Maintaining Data
• Use both batteries and the AC adaptor together.
• Make sure that batteries with sufficient power are loaded
whenever you disconnect the AC adaptor.
• Connect the AC adaptor to the keyboard and plug it into a
power outlet before replacing batteries.
Before connecting or disconnecting the AC adaptor or
replacing batteries, first press
B
bl
while in playback
Record
Standby Standby
Lights Flashes
4
(without
1
to turn off power.
Recording Your Keyboard Play
Using Tracks to Record and Mix
Parts
You can divide a song according to various types of parts
(instrument, left and right hand, etc.), and record each part to
a specific track. You can mix up to six tracks (the original track
plus five additional tracks) into a final song.
■ About tracks
Tracks are numbered from 1 to 6.
• If you do not specify a track number when recording,
recording is performed to Track 1 automatically.
In addition to what you play on the keyboard, the following
information also is recorded.
• Track 1
Settings:
Tone number, rhythm number, tempo, reverb, chorus,
chords, layer/split settings, Auto Harmonize/Arpeggiator
setting
Operations:
Pedal, pitch bend wheel (CTK-5000 only), INTRO button,
SYNCHRO/ENDING button, NORMAL/FILL-IN button,
VARIATION/FILL-IN button
• Tracks 2 through 6
Tone number, pedal operation, pitch bend wheel operation
(CTK-5000 only)
E-49