Table of Contents
Advertisement
(103CD) MODEL 8111 (MODEL 8110 + MODEL 51) DELUXE SALTWATER SYSTEM (SALT IN POOL) & FILTER PUMP ENGLISH 7.5" X 10.5" PANTONE 295U
The Saltwater System/Filter Pump must be installed as the last piece of
pool equipment in the water return line to the pool. This location extends
the life of the titanium plates.
Strainer & Plunger Valve Set Up (small AGP)
The strainer grid prevents large objects from jamming and/or damaging the
filter pump and the plunger valve assembly prevents water from flowing into
the filter pump while the filter cartridge is being placed or cleaned. If your
pool has inflatable top ring, install the strainer, nozzle and plunger valve
before inflating the pool liner top ring.
19
20
19
20
1. Grasp the strainer and plunger valve mechanism.
2. In a counter-clockwise motion unscrew plunger valve union from the threaded
strainer connector (24). Be careful not to lose the step rubber washer (21).
3. Grasp the plunger valve assembly. Make sure the step washer (21) is in place.
Connect adaptor B (27) to plunger valve union.
4. Repeat steps 1 through 3 for nozzle and plunger valve mechanism.
5. Remove wall plug and then insert the strainer (28 & 30) into the lower position
of protruding hose connection, and the nozzle (28 & 29) into the upper position
of protruding hose connection. Adaptor B (27) fits over the strainer
connection (28) inserted into the connection.
6. Examine the plunger valve to see if the handle is pushed fully down to the "0/1"
position. If not, then grasp the handle at the top and push down turning the
handle in a clockwise direction until the plastic protruding notch anchor is in
the "0/1" position. This will prevent water from flowing out during filling.
7. The pool liner is now ready to fill with water. Consult the above-ground-pool
owner's manual for filling instructions.
SAVE THESE INSTRUCTIONS
STRAINER & PLUNGER VALVE SET-UP
IMPORTANT
21
27
21
28
28
27
12/25/2007
103
CD
29
30
Page 12
Advertisement
Table of Contents
