Mounting The Loudspeaker - Bose FreeSpace FS4CE Installation Manual

Installation

Mounting the Loudspeaker

1. Pass the audio wire through the wire opening and through the input cover (not shown; see Preparing the Input Cover
on page 5).
2. Wire the connector and insert the connector into the loudspeaker. Tighten the conduit fitting if applicable. For wiring
information, see Wiring the Loudspeaker on page 6.
3. Insert the loudspeaker through the hole and into the tile bridge or rough-in pan (see page 7) and turn
(counterclockwise) the anchor arm screws one half turn to release the anchor arms. Slowly lower the loudspeaker until
the anchor arms engage on the tile bridge or rough-in pan.
4. Tighten the anchor arm screws to secure the loudspeaker.
WARNING: Over-tightening or over-loosening the screws may result in damage to the anchor arms, the anchor
attachment point, or the ceiling, which could lead to a falling hazard.
5. Place the input cover over the connector and press it firmly against the loudspeaker to create a tight seal. Use the two
included input cover screws to secure the input cover. See Preparing the Input Cover on page 5.
q
e
t
8 • English
w
r
PRO.BOSE.COM
FreeSpace FS4CE • Installation Guide