Care And Cleaning - Salton The Northern Lights Quick Start Manual

7. If you want to use the Kettle again, allow the thermal safety switch to
cool down for 15 to 20 seconds then lift the On/Off Switch to the On
position. If the On/Off Switch does not remain in the On position, the
water is hot enough to use without reheating.
8. Unplug cord from wall outlet before lifting Kettle from Power Base. Only
grip the Kettle by the handle as all other surfaces and the Lid will be hot.
9. Return the Kettle to the Power Base or place on a heat resistant surface
after use.
10. If the Kettle is accidentally switched on when empty, the thermostat
will automatically shut it off to prevent the Kettle from overheating.
If this situation occurs, unplug the Power Base and let the Kettle cool
before refilling.
11. It is recommended that the Power Cord be disconnected from the wall
outlet when not in use. DO NOT attempt to connect any other appliance
to the Power Base or tamper with the connector in any way.

CARE AND CLEANING

Use a soft, damp cloth to clean the exterior of the kettle. DO NOT use abrasive
cleaners. Dry thoroughly before use.
DO NOT ALLOW WATER TO ENTER THE POWER BASE
DO NOT IMMERSE THE KETTLE OR POWER BASE IN WATER OR OTHER LIQUID.
Descaling
Under normal use, a deposit of scale may form on the inside of the Kettle.
This build-up can be delayed by pouring out old water and refilling before
each use.
1. Unplug power cord from wall outlet and allow Kettle to cool before cleaning.
2. Remove Filter and wash under running water.
3. Scale which has accumulated inside the Kettle can be removed by boiling
equal parts of white vinegar and water (2 cups of each is recommended).
Once the water has boiled, allow mixture to stand overnight. Empty out
mixture and fill Kettle to the MAX level with fresh water. Bring water to a
boil and discard. For heavy scale build-up, repeat this process.
4