TO FILL AND TURN ON THE WATER HEATER
The power supply to the water heater must not be switched on until the
water heater is filled with water and a satisfactory megger reading is
obtained.
•
Open all of the hot water taps in the house (don't forget the shower).
•
Open the cold water isolation valve fully on the cold water line to the water
heater.
Air will be forced out of the taps.
•
Close each tap as water flows freely from it.
•
Check the pipe work for leaks.
•
Plug in the power supply cord at the power outlet (power supply cord model
only).
•
Switch on the electrical supply at the isolating switch to the water heater.
Explain to the householder or a responsible officer the functions and operation
of the water heater. Upon completion of the installation and commissioning of
the water heater, leave this guide with the householder or a responsible officer.
TO TURN OFF THE WATER HEATER
If it is necessary to turn off the water heater on completion of the installation,
such as on a building site or where the premises is vacant, then;
•
Switch off the electrical supply at the isolating switch to the water heater.
•
Unplug the power supply cord from the power outlet (power supply cord
model only).
•
Close the cold water isolation valve at the inlet to the water heater.
COMMISSIONING
30