Chapter 16. Cisco 10/100 Switch Replacement And Configuration; Replacement Of The 24-Port Switch; Remove The Rails From The Cabinet; Remove The Cisco 24-Port 10/100 Switch From The Rails - IBM Cluster 1350 Installation And Service

Chapter 16. Cisco 10/100 Switch replacement and
configuration
Contents

Replacement of the 24-port switch

To replace the Cisco 24-port 10/100 Switch, you must remove the rails from the

cabinet.

Remove the rails from the cabinet

1. Remove the mounting screws from the front vertical cabinet rails and remove
2. Remove the mounting screws from the rear vertical cabinet rails.
3. Slide the rails out the rear of the cabinet.

Remove the Cisco 24-port 10/100 Switch from the rails

Unscrew the Cisco 10/100 Switch from the rails. There are four holes on each side
of the devices.

Install the Cisco 24-port 10/100 Switch and rails

1. Mount the switch rails to the Cisco 24-Port 10/100 Switch. Mount the rails so
© Copyright IBM Corp. 2003
the cover bracket.
the Cable Management Tab is on the left rail, as shown in the figure below. Use
four screws on each side. Use the set of two large holes at the front of the rail
and the set of two large holes that are the third set from the back of the rail.
93